Skip to main content
  • Non-peer-reviewed research
  • Published:

A new concept for Urate in human serum: Evidences that support the existence of Urate as loosely associated and protein-bound Urate in human serum

Introduction

In this paper, it has been experimentally proved for the first time that urate is present in human serum bound to proteins. The protein-bound urates, when liberated, absorb in the ultraviolet light at wavelengths shorter than 293 - 295 nm, the wavelength at which the pure uric acid solution gives his maximum peak [1] .

Furthermore; the presence of other protein-bound substances which after being free, give rise to an increase in the absorption spectrum in the region between 270 and 300 nm and not attacked by uricase has been established.

Materials and Reagents

According to the fact that uric acid has its maximum absorbance in the U.V. light between the W.Ls of 290 nm and 295 nm under optimized conditions and making use of the specific destructive effect of uricase on uric acid, the absorption spectrum of a serum sample was carefully studied in the region between 270–300 nm before and after incubation with uricase.

Reagents

  • Sodium hydroxide solution ; 0.1 and 0.4 mol/L.

  • Tris buffer, pH. 8.5, 0.1 mol/L; Keep at 4°C.

  • Glycine buffer, pH. 9.35, 1.33 mol/L; Dissolve 50 grams of glycine and 8.8 grams of sodium hydroxide in 500 ml of distilled water, warm if necessary. Check the pH. Preserve with few drops of chloroform and keep at 4°C.

  • Uricase (urate : oxygen oxidoreductase, EC 1.7.3.3), 25 units in 25 ml of 0.1 mol/L Tris buffer, pH. 8.5, divide in 0.5 ml aliquots and keep frozen till use.

  • Uricase (urate:oxygen oxidoreductase, EC 1.7.3.3),25 unit in 1 ml of 0.1 mol/ L of glycine buffer pH 9.35, just before use.

  • Trichloroacetic acid (TCA) 50 g./L.

  • Uric acid standard solution, 5.949 mmol/L.

Experimentals

Incubation of diluted serum with uricase

To 6 ml of Tris buffer solution, 0.1 mol/L, pH. 8.5, in a test tube add 20 uL of serum and mix. Set up a standard by diluting 10 uL of the standard uric acid solution, 5.945 mmol/L, to a final volume of five ml with the Tris buffer solution. Record the absorbance in the region between 275 and 300 nm against the Tris buffer solution as blank. Add 0.1 unit of uricase (reagent 4) to each tube and incubate at room temperature (25°C) for two hours. Record the absorbance again for both the sample tube and the standard against the blank within the same range of wavelengths. Repeat the measurements after 48 hours incubations

Incubation of both the protein-free supernatant and the protein solution separately with uricase

To 200 uL of serum, add 1.8 ml of 50 g/L TCA, mix and centrifuge (1200 × g) for five minutes. Transfer 1 ml of the clear supernatant to a tube containing 3 ml of 1.33 mol/L glycine buffer, pH 9.35, and carry out the optical measurement in the region from 270–300 nm against a blank consists of 1 ml of 50 g/L TCA and 3 ml of the glycine buffer. On the other hand, dissolve the precipitated proteins in 5 ml of 0.1 mol/L sodium hydroxide solution, Buffer 1 ml of this solution with 3 ml of glycine buffer, 1.33 mol/L, pH 9.35 and carry out the optical measurements in the same way as with the clear protein-free supernatant. After the addition of 0.1 unit of uricase (reagent 4) to each of the buffered solutions, record the absorbance as before after incubation at room temperature (25°C) for two hours, 24 and 72 hours.

Incubation of the protein-free supernatant with uricase after treating the serum sample with sodium hydroxide solution 0.4 mol/L, at 60°C fore different periods

To each of three test tubes containing 200 uL of a serum sample,add 0.8 ml of 0.4 mol/L sodium hydroxide solution, mix and leave in water bath 60°C.

After 5 minutes add 1 ml of 0.2 mol/L citric acid, mix and leave for further 1 minutes in the bath. After centrifugation (1200 × g) transfer 1 ml of the clear supernatant to another tube containing 3 ml of glycine buffer 1.33 mol/L pH 9.35 and keep ready for optical measurements.

Repeat this step with the other two test tubes after leaving in the water bath 60°C for periods of 10, and 15 minutes respectively.

Record the U.V spectrum for each of the three tubes in the region between 270 and 300 nm.; Then add 5 units of uricase (reagent 5) to each tube, mix and leave at room temp. (28°C) for two hours. Record the absorbance again in the same region of W.Ls.

Results

The results obtained are illustrated in tables 1,2 and figures 1,2,3,4 &5.

Figure 1
figure 1

Curve (a) represents the difference between the absorbance before and after incubation of the diluted serum sample with uricase for two hours. The max. decrease was recorded at 283–285 nm. Curve (b) represents the difference between the absorbance before and after the action of uricase for two hours on the pure uric acid solution. The max. decease was recorded at 293 nm

Figure 2
figure 2

Curve (a) represents the difference between absorbance of the precipitated- protein solution before and after 24 hours incubation with uricase. The max. decrease obtained was at 283 nm. Curve (b) represents the difference between absorbance of the protein-free solution before and after 2 hours incubation with uricase. The max. decrease obtained was at 293 nm.

Figure 3
figure 3

The absorption spectra of the protein-free supernatant after leaving the serum sample for 5 minutes with sodium hydroxide solution 0.4 mol/L at 60°C. (a)- Before destruction with uricase. (b)- After destruction with uricase. The maximum decrease in absorbance recorded was at 295 nm,the same W.L at which the free uric acid solution gives its maximum absorption peak.

Figure 4
figure 4

The absorption spectra of the protein-free supernatant after leaving the serum sample for 10 minutes with sodium hydroxide solution 0.4 mol/L at 60°C. (a)-Before destruction with uricase. (b)-After destruction with uricase. The maximum decrease in absorbance recorded was at 295 nm,the same W.L at which the free uric acid solution gives its maximum absorption peak. More urate were liberated and absorb in the region between 290–295 nm.

Figure 5
figure 5

The absorption spectra of the protein-free supernatant after leaving the serum sample for 15 minutes with sodium hydroxide solution 0.4 mol/L at 60°C. (a)-Before destruction with uricase. (b)-After destruction with uricase. The maximum decrease in absorbance recorded was at 295 nm,the same W.L at which the free uric acid solution gives its maximum absorption peak. More urate were liberated and absorb in the region between 287–290 nm.

Table 1 The absorption spectra of both the diluted serum sample and the pure uric acid solution before and after the action of uricase
Table 2 The absorption spectra of both the precipitated protein solution and the protein-free supernatant before and after the action of uricase

Table 1 (a,b) & figure 1-curve a; denote a maximum decrease in absorbance at 283–290 nm after the action of uricase on the buffered diluted serum. On the other hand, the strongest band recorded for the pure uric acid solution was at 293 nm, table 1 { U0-U2) } & figure 1 curve-b; the same wave length at which urate in the buffered protein-free clear supernatant also gives its maximum peak., Table 2 (A0 - A2.), figure 2b.

In addition, table 2, B0 - B24, & figure 2a; show a maximum decrease in absorbance at 283-285 nm when the buffered protein solution was left under the action of uricase for 24 hours.

After longer incubation periods, 48 hours, table 1, C & table 2, B72, the recorded absorbance was higher than the original values obtained before the action of uricase, table 1, A & table, B0.

The absorption spectra of the clear protein-free supernatant after subjecting the serum for the action of sodium hydroxide solution 0.4 mol/L at 60°C for 5, 10 and 15 minutes, before and after destruction with uricase, as presented in figures 3,4 and 5 showed maximum decrease in absorbace at 295 nm – the same W.L at which the free uric acid gives its maximum absorption peak –, along the experiment periods of time (5,10 & 15 minutes),

Moreover, after 15 minutes, more urate were liberated and absorb at 290 nm – figure 5.

Discussion

The results showed a remarkable difference in the wave lengths (W.Ls) at which urate in serum gives its maximum absorbance, 283–290 nm, compared to 293 nm, the W.L. at which the pure uric acid solution gives its maximum band.

This, could be attributed to the presence of a sort of co-ordination between serum urates and proteins under physiologic conditions. As soon as the proteins were precipitated, part of the serum urates were identified in the protein-free supernatant at the same wavelength at which the free uric acid solution has its maximum peak. This part of serum urate is easily attacked by uricase.

The other part of serum urate appeared to be relatively strongly bound to proteins and is hardly attacked by uricase. After being free, it absorbs at shorter W.Ls, 283–285 nm (experiment [2]).

This might be understood on the basis of the old suggestion of gudzent [2] that both the lactam (keto) and the lactim (enol) toutomers of uric acid might be stable enough to coexist in biological fluids under certain circumstances.

In serum, these forms are expected to co-ordinate with proteins through hydrogen bonding. The energy of the hydrogen bond varies from 8.37 kJ for the H-N...H to 29.29 kJ for the H-O...H [3]. Therefore, it appears that the lactim toutomer will be relatively more strongly bound to proteins. Since the hydrogen bond by itself is a weak bond, this can explain why the loosely associated urate (lactam) is easily liberated as soon as the folded (quaternary) structure of proteins was disturbed. However the existence of protein-bound urate (PBU) could not be simply explained on the basis of hydrogen bond formation between the lactim toutomer of urate and proteins. Other type of co-ordinations might be involve to give that relatively stable protein-bound substance (PBU).

On the other hand, the hydrogen bond formation causes a relatively large amount of polarity in serum urate as compared to the pure uric acid solution. This may explain the spectral shifts in the absorbance maximum (283–290 nm) of serum urate compared to 293, 295 nm for the pure uric acid solution at the same pH (8.5, 9.35). Also this may explain the relative shift in the absorbance of the more polar lactim (PBU) to shorter W.Ls as compared to the relatively less polar lactam.

In addition, further investigation of the absorption spectra of serum between 270 nm and 300 nm before and after destruction with uricase demonstrate the presence of protein-bound substances which give their absorption spectra, after liberation from proteins, in the UV light at the W.Ls characteristic to uric acid or urate in serum and not affected by uricase. The rates of liberation of these substances differ than the rate of destruction of uric acid by uricase.

This represents the major obstacle against any attempt to record the real decrease in absorbance at 283–285 nm when serum proteins or the serum were subjected for the action of uricase. Actually, the results obtained are the difference between decrease in uric acid due to the destructive action of uricase and the increase of these liberated substances from proteins .

At the beginning, the rate of destruction of uric acid is higher than the rate of liberation of these substances, the result is a decrease in absorbance at 283–285 nm, the W.L. characteristic for urate max. absorbance in serum.

By the time the rate of liberation of these substances is increased in relation to the destruction rate of urate, this gives rise to increase in absorbance not only at the specific W.L characteristic to urate max. absorbance in serum, but also in the region from 270–300 nm.

Obviously, these substances will interfere with determination of serum urate if the measurements were carried out in the ultraviolet light after destruction with uricase.

At shorter U.V W.Ls,the blank is too high to record any change.

References

  1. Praetorius E, Poulsen H: Enzymatic determination of uric acid with detailed directions. Scand. J. Clin. & Lab. Inves . 1953, 5: 273-280.

    Article  CAS  Google Scholar 

  2. Gudzent : Quantitative Clinical Chemistry, (Peters, J. P., and Van Slyke, D.D., Ed.) vol. Williams's Wilkins Company, Baltimore, and I table. 1946, 24: 635-

    Google Scholar 

  3. Finar IL: Organic Chemistry, volume I, The English Language Book. Society and Longman group Limited,. 1973, 40-

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Ahmed Nabil Hegazi Ph.D..

Rights and permissions

Reprints and permissions

About this article

Cite this article

Nabil Hegazi, A. A new concept for Urate in human serum: Evidences that support the existence of Urate as loosely associated and protein-bound Urate in human serum. Arthritis Res Ther 3, E002 (2001). https://doi.org/10.1186/ar312

Download citation

  • Published:

  • DOI: https://doi.org/10.1186/ar312

Keywords